i have got replacement pads and discs for my car but when i went 2 put the pads into caliper, they were to tight. i checked the size of the pads and discs against the old one and r the same. the only thing i can think of is that the calipers r coroded. I priced new brembo calipers and the dealer is 677+vat each for calipers. Is this a problem? And can i get them anywhere cheaper

 

Did you push the pistons all the way in before trying to slide the pads in?

 

x2 on pushing the piston back

 

x3, PLUS: file/scrape/wire brush the caliper where it's too tight.

 

Yea pistons were pushed right back, on taking the calipers of the bolt broke on one of the calipers, due 2 the 2 metals reacting together. The slides the pads ends would seat on the aluminium below them looked corroded and stopping the pads from going in. P.s the pads I took out more r less needed a kango hammer 2 get them out