worbs

iTrader: (8)

Hi folks, iv got some 18" inovit redlines from a friend that had them on his 2000 classic i tried putting them on my 94 jdm classic today but they dont seem to fit correctly. They seem to sit so the studs are not in the centres on the holes so the wheel nuts wont do up without fouling the sides of the holes if that makes sense.
Im not sure on offsets or anything but the wheels originaly came from a 96 wagon then the 2000 classic so surely they should fit mine shouldn`t they?,
or am i being a numpty and doing something wrong.

wrxsti280

iTrader: (6)

i would think they would centre themselves as you tighten them up, unless you have the wrong taper on the wheelnuts for the design of the wheels???

JDM_Stig

iTrader: (3)

as above, no real reason for the wheels not too fit.

scoobymoz

iTrader: (53)

Have you got the spigot rings fitted? that would make the wheel sit off center.

worbs

iTrader: (8)

Thanks for the replys fellas, i think the nuts are ok, i will check if the spigot rings are on there, i must admit i didn`t before as was in a bit of a hurry.

Thanks

Ian

M444GY

iTrader: (72)

they should fit strait on mate . check the spigot rings are not fouling

worbs

iTrader: (8)

Thanks fella, will check sat when next up the workshop