Is there a right and wrong way to fit Mintex 1144's
#1
As above, I have a 325mm Kit with AP 4-pots and 1144 pads. The Mintex pads do have a small letter "L" on the side of the pad does this mean "LEFT" or "LEADING" or does it mean nothing!
Need help as they are squeeling like mad when brake at less than 20 mph
Russell
Need help as they are squeeling like mad when brake at less than 20 mph
Russell
#4
Were are the biggest suppliers of Mintex here in Ireland. The squeal has been a constant problem. It is greatly reduced by fitting a set of anti squeal rubber pads to the back of your pad. It should be available from your pad supplier. Solves the problem in 90% of the cases.
Paul.
Paul.
#6
Macs Power - thanks for the info, same as the kit supplier stated and he is sending me some pads for that specific purpose!
Ian - email sent to you ten minutes ago, thanks for your interest to help in the situation. I do appreciate it
To all, a good day!
Russell
Ian - email sent to you ten minutes ago, thanks for your interest to help in the situation. I do appreciate it
To all, a good day!
Russell
Thread
Thread Starter
Forum
Replies
Last Post
DogsofWar
Engine Management and ECU Remapping
16
23 September 2015 07:41 PM