AP 6 pot 355x32 mm
#1
AP 6 pot 355x32 mm
Another fitment question
I have original 18 inch OZ P1 wheels under my Type R.
I am planning to buy AP 6-pots from RCM
Size of the discs will be 355x32 mm.
I know that this size will fit in 18 inch.
Will these calipers fit in the rims?
Has anybody got this AP kit with these rims? With pitures?
Thanks
I have original 18 inch OZ P1 wheels under my Type R.
I am planning to buy AP 6-pots from RCM
Size of the discs will be 355x32 mm.
I know that this size will fit in 18 inch.
Will these calipers fit in the rims?
Has anybody got this AP kit with these rims? With pitures?
Thanks
#2
Scooby Regular
Join Date: Jun 2002
Location: Stoke-on-Trent
Posts: 674
Likes: 0
Received 0 Likes
on
0 Posts
Hi,
Are your wheels ET53 (stamped on inside edge of rim)?
See pic of 355 x 32 AP 6 Pot's on my thread here: https://www.scoobynet.com/private-sa...-11-500-a.html
I'd also recommend downloading the template from AP's site and trying that inside a wheel.
You should change the wheel studs too as the AP bells are thicker than the subaru ones and won't leave you enough thread to keep your wheels on!
Best regards,
Ian
Are your wheels ET53 (stamped on inside edge of rim)?
See pic of 355 x 32 AP 6 Pot's on my thread here: https://www.scoobynet.com/private-sa...-11-500-a.html
I'd also recommend downloading the template from AP's site and trying that inside a wheel.
You should change the wheel studs too as the AP bells are thicker than the subaru ones and won't leave you enough thread to keep your wheels on!
Best regards,
Ian
#3
It's worth trying your wheels over the 355mm kit fitted to some one else's car, as RCM (fitted mine) said they once had a problem with fitting a set of P1 OZ Prodrive alloys over the kit - even though they seemed to have the same serial no's as another set of P1 alloys which did fit (both looked identical - and were the 18 inch versions).... Mine's there at the moment but am collecting it tomorrow - you're welcome to try your wheels if you're local to RCM and around tomorrow? Otherwise, I think the Gobstopper car has the 355mm kit on, so am sure RCM wouldn't mind checking for you if you're there (assuming you aren't mail ordering!).
Thread
Thread Starter
Forum
Replies
Last Post
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM
Matt_182
Wheels, Tyres & Brakes
19
07 October 2015 01:05 PM