Im lookin for the size of the front and rear discs for MY01 Classic Turbo2000 i think the front ones are 295mm but not sure could someone confirm this. Also what size are the rear discs? should i be looking for vented, grooved or drilled discs?? im rather new to all this only had the scooby for 2 weeks so would really appretiate advice from someone in the know

Thanks Melon.

 

AFAIK you should have 294mm fronts and 266mm rears, all vented.

For aftermarket, go for grooved only as cross drilled can crack.
Remember its mainly down to the quality of your pads.

Also consider stainless steel brakelines, decent fluid and possibly a brake support bracket to prevent bulkhead flex.

 

just to drive the point stated above home I have to agree about the rotors. I've seen cross-drilled rotors crack on daily drivers, not to mention weekend warriors. It all depends on what you're doing with your car, most of the time a good vented plain rotor like a brembo will be all you need, with some good pads of course. And there's a huge difference in brake feel and response with braided lines. oh and the cheapest/best way to improve brakes is bleed them thoroughly

 

eBay.co.uk: SUBARU IMPREZA WRX GROOVED BRAKE DISCS FRONT REAR P1 (item 200072790598 end time 04-Feb-07 15:48:12 GMT)

Saw these on ebay was wondering if they are anygood, from what i can gather they are made by Brake Engineering.

Cheers Melon.

 

can anyone help please im a newbie