Replacing my godspeeds
#1
Scooby Regular
Thread Starter
Join Date: May 2002
Location: www.ayrshirescoobies.com
Posts: 2,079
Likes: 0
Received 0 Likes
on
0 Posts
Replacing my godspeeds
Need to replace my godspeed 330mm discs but i don't have the money at the moment.
So the question is, what front discs can I use without having to remaove the spaver in the caliper and the hub brackets?
Thanks
Ricey
So the question is, what front discs can I use without having to remaove the spaver in the caliper and the hub brackets?
Thanks
Ricey
#2
Scooby Regular
Don't think any other disc fits Ian's alloy bell (oh er), but I could be wrong.
Either you leave as is and find another large 335mm disc that is the same width and offset to fit inside the caliper with the brackets - very doubtful, if not impossible
OR
Remove the bracket (easy job) and find a thick disc in std diameter - again probably impossible + you'll need std pads
OR
remove the caliper and bracket and fit cheap std discs/pads. You'll need to give the system a bleed once you put the std kit back on. Easy enough (I did it), but it's a bit time consuming.
OR
get a bus
Either you leave as is and find another large 335mm disc that is the same width and offset to fit inside the caliper with the brackets - very doubtful, if not impossible
OR
Remove the bracket (easy job) and find a thick disc in std diameter - again probably impossible + you'll need std pads
OR
remove the caliper and bracket and fit cheap std discs/pads. You'll need to give the system a bleed once you put the std kit back on. Easy enough (I did it), but it's a bit time consuming.
OR
get a bus
#4
Scooby Regular
Thread Starter
Join Date: May 2002
Location: www.ayrshirescoobies.com
Posts: 2,079
Likes: 0
Received 0 Likes
on
0 Posts
Cheers Ozzy, might just start using my REAl car, if i can handle the power!!
1.1 punto!!
You have a point Neil, its very difficult when everthing you want comes up at once!! ;-)
Ricey
1.1 punto!!
You have a point Neil, its very difficult when everthing you want comes up at once!! ;-)
Ricey
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Phil3822
General Technical
0
30 September 2015 06:29 PM