Will this spec fir an Impreza
30 June 2005, 10:11 PM
#1
Scooby Regular
Thread Starter
Join Date: Feb 2005
Location: glasgow
Posts: 799
Likes: 0
Received 0 Likes
on
0 Posts
Will this spec fit an Impreza
I spotted a nice set of alloys for sale
They are 5 stud with the following spec
Size: 7 x 16”
PCD: 5x112 mm
ET: 50mm
C/BORE: 57.1mm
Thanks
Grant
They are 5 stud with the following spec
Size: 7 x 16”
PCD: 5x112 mm
ET: 50mm
C/BORE: 57.1mm
Thanks
Grant
Last edited by sti-spec-a; 01 July 2005 at 07:56 PM.
01 July 2005, 09:42 PM
#3
Scooby Senior
Join Date: Feb 2003
Location: West Midlands
Posts: 1,903
Likes: 0
Received 0 Likes
on
0 Posts
I think with the offset you will be ok et50.
But I am not sure of pcd 112mm? Guess thats diameter of the position of the holes for the studs or wheel bolts. I think this will cause problems when doing up the wheel bolts.
My p1 alloys are as follows: et52 & pcd 100 X 5
But I am not sure of pcd 112mm? Guess thats diameter of the position of the holes for the studs or wheel bolts. I think this will cause problems when doing up the wheel bolts.
My p1 alloys are as follows: et52 & pcd 100 X 5
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Jonny mac
ScoobyNet General
10
09 October 2015 12:25 PM