Does anyone have a note of the offset measurements for the various types of Scoobies out there?

The Calibra I am trading in has spanking 17" Kahn RSR's which I believe have an offset of 49mm. I have the original vauxhall alloys so it would be a bonus if they fit the Subaru.

If not then the cash I get when I sell them will do me just fine

 

Hope this helps, as far as i know most subaru models had around 50mm offset. Most aftermarket wheels range from 45-55mm depending on the make. So the offset is fairly much the same as vauxhall, however most calibras were only 4X100 stud pattern (except v6 and turbo 5x110) whereas the subarus use 5x100. So i'm afraid theres no way of fixing them on.

 

Heh, thanks for that I Guess I'll be selling them to my mate with the Vectra

 

Yep that's about right... 5 stud PCD 100, but I think you may find that both Vauxhall and Subaru offsets at 45mm -55mm are on the high side in comparison to most normal stuff?