Brake Stopper / Master Cylider Brace
30 March 2004, 10:14 AM
#1
Scooby Regular
Thread Starter
Join Date: Apr 2001
Location: Perth and Iran
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
Brake Stopper / Master Cylider Brace
Guys / Gals,
Can anyone help with this one ? I have just purchased a Cusco Brake stopper, thats the Brace that mounts to the suspension turret and then to the Master cylinder manifold. The install pics were crap and the kit is not exactly self explanatory / aswell as being Japanese ! - Can anyone enlighten me on the correct fitting procedure and any special setup ??
EwanS
Can anyone help with this one ? I have just purchased a Cusco Brake stopper, thats the Brace that mounts to the suspension turret and then to the Master cylinder manifold. The install pics were crap and the kit is not exactly self explanatory / aswell as being Japanese ! - Can anyone enlighten me on the correct fitting procedure and any special setup ??
EwanS
30 March 2004, 11:23 AM
#2
Scooby Regular
It's similar to the MRT Brake Support Bracket, but I see it mounts slightly differently.
AFAIK, it's pretty basic to install. You just bolt it to the suspension turret and tighten it to the Master Cylinder. It's just to stop movement, so I guess as long as it prevents this it will have the desired effect.
Only bit that may need adjusting is how tight it is against the MC. I would say bolt it on nd then experiment with this.
Stefan
AFAIK, it's pretty basic to install. You just bolt it to the suspension turret and tighten it to the Master Cylinder. It's just to stop movement, so I guess as long as it prevents this it will have the desired effect.
Only bit that may need adjusting is how tight it is against the MC. I would say bolt it on nd then experiment with this.
Stefan
06 October 2005, 08:40 AM
#4
I've just got one of these. Fitting instructions in foreign.....
2 of the brackets and the stopper are fairly self-explanatory, but I can't really see where the 3rd bracket goes. It's bent both ends in opposite directions, with a lug half way down the side.
Any pics of one installed would be appreciated....
2 of the brackets and the stopper are fairly self-explanatory, but I can't really see where the 3rd bracket goes. It's bent both ends in opposite directions, with a lug half way down the side.
Any pics of one installed would be appreciated....
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
