Brake Stopper / Master Cylider Brace
 

Guys / Gals,
Can anyone help with this one ? I have just purchased a Cusco Brake stopper, thats the Brace that mounts to the suspension turret and then to the Master cylinder manifold. The install pics were crap and the kit is not exactly self explanatory / aswell as being Japanese ! - Can anyone enlighten me on the correct fitting procedure and any special setup ??
EwanS

It's similar to the MRT Brake Support Bracket, but I see it mounts slightly differently.

AFAIK, it's pretty basic to install. You just bolt it to the suspension turret and tighten it to the Master Cylinder. It's just to stop movement, so I guess as long as it prevents this it will have the desired effect.

Only bit that may need adjusting is how tight it is against the MC. I would say bolt it on nd then experiment with this.

Stefan

Cheers Stefan
EwanS

I've just got one of these. Fitting instructions in foreign.....
2 of the brackets and the stopper are fairly self-explanatory, but I can't really see where the 3rd bracket goes. It's bent both ends in opposite directions, with a lug half way down the side.

Any pics of one installed would be appreciated....

Found this....
https://i23.photobucket.com/albums/b...aylor/stut.jpg

It looks like the 3rd bracket just moves the bonnet release or throttle cabel out of the way.