Break conversion wrx-Sri blobeye 02- oz p1s
#1
Scooby Newbie
Thread Starter
Break conversion wrx-Sri blobeye 02- oz p1s
Hi all, I’m wanting to change over to the brembo STIs , I’ve been reading that the standard allloys are different and don’t have enough space ? I have p1 pro drive alloys on them , will they be fine to do a conversion on? Not long had both callipers refurbed with big red kit but car is pushing 300bhp and need some more stopping power .
is it as simple as taking them off bolting new ones on? Or will I need a full conversion kit?
cheers
is it as simple as taking them off bolting new ones on? Or will I need a full conversion kit?
cheers
#2
Scooby Regular
iTrader: (2)
Tin of worms Pull off a wheel and see what ET they are if ET53 they won't fit if ET46 they will fit BUT your maximum tyre width will be 215 otherwise they may buff. Apart from that they will bolt straight on just make sure you have the Brembo caliper bolts as they are a different pitch.
Last edited by 1509joe; 22 October 2021 at 01:24 PM.
The following users liked this post:
#3
Scooby Newbie
Thread Starter
Tin of worms Pull off a wheel and see what ET they are if ET53 they won't fit if ET46 they will fit BUT your maximum tyre width will be 215 otherwise they may buff. Apart from that they will bolt straight on just make sure you have the Brembo caliper bolts as they are a different pitch.
Thread
Thread Starter
Forum
Replies
Last Post
currymonster
Wheels, Tyres & Brakes
3
02 December 2003 06:39 PM