Dave Y

iTrader: (52)

tried to get a front wheel off,it was stuck solid. I fannied about tapped it all over but it wouldnt budge.
Any tips any tricks ?

Recovery Ray

jack car off the ground not too high make sure if safe to lie under car, use a lump hammer and block of wood to protect inside rim and go around rim and hit it like a ba*tard,no tapping. (turning wheel as you go!).
put a piece of old carpet on the ground just in case wheel jumps off to save alloy from damage.
clean both surfaces and smear with copper slip grease,so next time you wont have to fanny about.

The Pink Ninja

iTrader: (23)

Once you have the nuts off put one back on loosely then...kick the fcucker at the bottom on the tyre

Are they freshly painted or powder coated wheels you're removing for the first time?

Dave Y

iTrader: (52)

no.
i will try again later.

JDM_Stig

iTrader: (3)

Loosen wheel nuts and drop off jack, or just drive a meter, don't loosen the nuts too much, just a turn off fully tight so it breaks the rust seal,
Use more copper grease when you put it back on lol.

stifmeister

Had this on an old bmw once. Only way I could get it off was levering with a long steel bar. Don't get underneath when doing this!