Neilo spotted again!
#1
Scooby Regular
Thread Starter
Join Date: Jul 2003
Location: Behind the wheel of a Time Attack R33 GTR
Posts: 5,734
Likes: 0
Received 0 Likes
on
0 Posts
you have an STI back box? im just about to fit one, did you fit it yourself? was it easy?? let me know mate asap!
edited to say, unless u feel like giving me a hand!! never fitted anything before in my life!
[Edited by Neilo - 11/8/2003 12:43:50 AM]
edited to say, unless u feel like giving me a hand!! never fitted anything before in my life!
[Edited by Neilo - 11/8/2003 12:43:50 AM]
#3
Scooby Regular
Thread Starter
Join Date: Jul 2003
Location: Behind the wheel of a Time Attack R33 GTR
Posts: 5,734
Likes: 0
Received 0 Likes
on
0 Posts
woohoo! i believe i did, you were turning in to the industrial estate, i didnt see you until late so would have looked a prat if id tried to wave! sorry about that! (sun was in my eyes)
nice motor
nice motor
#5
Scooby Regular
iTrader: (2)
Join Date: Apr 2002
Location: Buckinghamshire
Posts: 1,818
Likes: 0
Received 0 Likes
on
0 Posts
Neilo,
yes fairly easy. I jacked the car up using a trolley jack on the diff with a piece of wood on it to avoid marking anything, placed a pair of axle stands under the 2 jacking points for safety. Crawled underneath, undone the 2 x 14mm bolts that attach the backbox to the rest of the exhaust, undone 14mm bolt at rear rubber hanger (nut welded, so you don't need to hold it) prise off the other 2 rubber hangers and then do the reverse to fit. Hangers are not easy to prise off, but I used some copper grease on them to refit and they slide on much easier. Don't forget to refit the gasket between the box and rest of pipe. Easily a DIY job!
Andy.
yes fairly easy. I jacked the car up using a trolley jack on the diff with a piece of wood on it to avoid marking anything, placed a pair of axle stands under the 2 jacking points for safety. Crawled underneath, undone the 2 x 14mm bolts that attach the backbox to the rest of the exhaust, undone 14mm bolt at rear rubber hanger (nut welded, so you don't need to hold it) prise off the other 2 rubber hangers and then do the reverse to fit. Hangers are not easy to prise off, but I used some copper grease on them to refit and they slide on much easier. Don't forget to refit the gasket between the box and rest of pipe. Easily a DIY job!
Andy.
Thread
Thread Starter
Forum
Replies
Last Post