Possible engine
21 February 2012, 02:07 PM
#1
Scooby Regular
Thread Starter
iTrader: (9)
Join Date: Nov 2010
Location: Hertfordshire
Posts: 485
Likes: 0
Received 0 Likes
on
0 Posts
Possible engine
Just rebuilt mine, and then on drive home it stopped, and hasnt started since. mechanic doing a compression test on mornoing, but I thought Id prepare for the worst and ask if anyone has a good v3-4sti engine?
Wouldnt mind a rebuilt lump that has been running ( especially if its been done well
)
Sean
Wouldnt mind a rebuilt lump that has been running ( especially if its been done well
) Sean
21 February 2012, 02:51 PM
#2
Scooby Regular
iTrader: (7)
Join Date: Apr 2008
Location: Nottinghamshire
Posts: 280
Likes: 0
Received 0 Likes
on
0 Posts
Got a V4 STI engine from an RA in my Type R currently.
Was put in over winter and has seen 300 miles since. Has rebuilt heads, original bottom end. However fully cleaned, painted block, cam casing etc. Inlet manifold is sprayed purple, red samco pipes for turbo intake, intercooler etc. Ran 323hp safe on rollers last year with a simtek. No det, knocks or pings when used. Haven't had chance to use it in mine tbh, put pulls very well. Got a couple of videos of engine running too. Just been serviced and comes with goodies such as RCM equal length headers and up pipe, lightweight crank pulley etc too. 68k miles.
Pictures in my type r for breaking topic.
Was put in over winter and has seen 300 miles since. Has rebuilt heads, original bottom end. However fully cleaned, painted block, cam casing etc. Inlet manifold is sprayed purple, red samco pipes for turbo intake, intercooler etc. Ran 323hp safe on rollers last year with a simtek. No det, knocks or pings when used. Haven't had chance to use it in mine tbh, put pulls very well. Got a couple of videos of engine running too. Just been serviced and comes with goodies such as RCM equal length headers and up pipe, lightweight crank pulley etc too. 68k miles.
Pictures in my type r for breaking topic.
21 February 2012, 03:56 PM
#3
Scooby Regular
iTrader: (8)
Join Date: Jul 2008
Location: Neath,wales
Posts: 2,234
Likes: 0
Received 0 Likes
on
0 Posts
Got a V4 bottom end, done 5k since build with acl race bearings. £500 if you arrange pick up yourself
Last edited by R1CH D; 21 February 2012 at 06:17 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM