MAF from Hawkeye
I'm sick as a chip! Nowt ever goes right with my car. Now it's idling all over the shop. Just clutching at straws with trying a new MAF.
Everything is pointing to the modified injectors I fitted so hopefully flow testing them soon. Bob is coming to check the map on the 14th Feb so need to have everything "resolved" by then.
Have you tried cleaning the maf ?
When you say modified injectors - what have you put in versus what was in there and has it been mapped for them ? If you have put much larger injectors it will be running pig rich until mapping.
When you say modified injectors - what have you put in versus what was in there and has it been mapped for them ? If you have put much larger injectors it will be running pig rich until mapping.
It's been mapped with the modified injectors in. It was fine when Bob and Harvey had it out. Got back to Harvey's and I was pulling away, it started to go to rat****. It's so bad on idle that it's been stalling with clutch to the floor, dash lights going off etc.
Had an idle problem when fitting my 20g on. I hadn't taken a chunk out of the bellhousing area, so the 20g was mounted with its bottom water pipe stopping a flush fit on to the uppipe.
This resulted in an uppipe gasket leak (couldn't be heard) with the idle and fuelling all over the place.
Did you take the manifold off to do the injectors? This could also lead to an air leak if not sealed properly.
Nick
This resulted in an uppipe gasket leak (couldn't be heard) with the idle and fuelling all over the place.
Did you take the manifold off to do the injectors? This could also lead to an air leak if not sealed properly.
Nick
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
MightyArsenal
Wheels, Tyres & Brakes
6
Sep 25, 2015 08:31 PM



