Bottom end parts for classic 98 wrx
15 March 2008, 07:06 PM
#1
Scooby Regular
Thread Starter
Join Date: Mar 2008
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Bottom end parts for classic 98 wrx
This is for a mate, his bottom end has just went on his classic 98 wrx, any second hand parts to help with the rebuild?
Any advise would be gratefull too!
Any advise would be gratefull too!
25 March 2008, 12:01 PM
#4
Scooby Newbie
Join Date: Mar 2007
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
USDM 2.5L Sti Block and 2.5 RS Heads - £1000
The Block comes with the block itself, std pistons, std rods, std crank(very strong), RS Heads, intake manifold, oil pump. Right now it's in pieces because that's how I had it shipped over from the states. However, all it would need are some new rings and bearings and you have yourself a new engine. There is still very visible cross-hatchingI had planned to pick up some forged rods and bearing to make a forged bottom end (I can get them for you from the states - it'll take a few weeks if I order now).
--If you want some forged Rods and Pistons I can get those for about £450 and with them, you are looking at a very strong engine.
The heads are compete except for the cam gears and a sensor or 2. I've also go an intake manifold for them. All said and done, you could build the engine, and when you go to install it in the car, just take a few things from your EJ20.
If you want some pics of it, let me know.
email me at wernickt@hotmail.com
The Block comes with the block itself, std pistons, std rods, std crank(very strong), RS Heads, intake manifold, oil pump. Right now it's in pieces because that's how I had it shipped over from the states. However, all it would need are some new rings and bearings and you have yourself a new engine. There is still very visible cross-hatchingI had planned to pick up some forged rods and bearing to make a forged bottom end (I can get them for you from the states - it'll take a few weeks if I order now).
--If you want some forged Rods and Pistons I can get those for about £450 and with them, you are looking at a very strong engine.
The heads are compete except for the cam gears and a sensor or 2. I've also go an intake manifold for them. All said and done, you could build the engine, and when you go to install it in the car, just take a few things from your EJ20.
If you want some pics of it, let me know.
email me at wernickt@hotmail.com
Last edited by tkw24; 25 March 2008 at 12:03 PM. Reason: .
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
BHPvstorque
Subaru Parts
1
14 September 2015 08:31 PM