A knackered MY97/98 intercooler
#1
I'm after a knackered MY97/98 intercooler (the type with dump valve NOT attached directly to the IC. Or to be more precise, I just want the elbow that leads to the dump valve, hacksawed or something off the I/C. It's for a project of STI5 I/C to fit my MY98.
#3
I sure do! But where's the challenge in that? Plus, £80 for a few bits of stainless steel!!! I'm not paying them that kind of money if only as a matter of principle.
Thread
Thread Starter
Forum
Replies
Last Post
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM