anyone in the swansea area to help refit my dails as the speedo and temp and fuel gauges not working cheers

 

fella as mentioned in previous post on this subject they are now fooked m8 as your meant to cut the corners from what i have read them dials have ballast resistors in them if you disturb them there booggered........

so im led to believe......

if you look at this pic

you will see on the bottom left of fuel gauge there is a slot also on the bottom right of temperature gauge there is another slot they have done this for a reason obviously...on the lockwood site on the bottom it says
NOTE:THE NEEDLES ON THE SPEEDO AND REV COUNTER NEED TO BE REMOVED TO FIT THESE DIALS
notice they dont mention the fuel or temperature gauges
so i think its time for some new clocks m8

ceri

 

just noticed speedo isnt working either have you pushed the cable all the way home on the back of the clocks as if you notice the end of the cable is square and it needs to go in the square on the back of the clocks for them to mate up

ceri

 

Thanks for that drive iam looking for some new dails now but a bit of good news i had my chip soiled today it really goes well now

 

did you get the speedo working m8???
Subaru Impreza WRX / STI Speedo,fuel gauge. DASH CLOCKS on eBay, also, Subaru, Car Parts, Cars, Parts Vehicles (end time 16-Dec-07 15:17:19 GMT)
middle one lowest mileage
Subaru Impreza WRX / STI Speedo,fuel gauge. DASH CLOCKS on eBay, also, Subaru, Car Parts, Cars, Parts Vehicles (end time 16-Dec-07 15:21:04 GMT)
bottom one cheapest
Subaru Impreza WRX / STI Speedo,fuel gauge. DASH CLOCKS on eBay, also, Subaru, Car Parts, Cars, Parts Vehicles (end time 16-Dec-07 15:24:50 GMT)

good luck ceri

 

iam just wondering if i should swop my red scooby dials with are proper with dials over to silver one but ive got to change the mileage as well what do you think of that ceri

 

thats easy the speedo unit and should just unscrew

 

hi ceri ive just put some dails back in but the speedo still not working ive made shaw that the converter was push on properly and the cable but still nothing plus iam wondering do i have to put this coverter on as ive had the chip put in my ecu now and they say that delimted it