Powerflex & STi Anti Roll bar
#1
Shredded a front anti-roll bar mounting on track. Three q's:
What diameter anti roll bar would a 1999 STi V have?
Is it a doddle to fit, or do I have to remove the drop links and everything to slide the new bushes on?
Any negatives about replacing with Powerflex bushes?
Thanks for any advice!
D
What diameter anti roll bar would a 1999 STi V have?
Is it a doddle to fit, or do I have to remove the drop links and everything to slide the new bushes on?
Any negatives about replacing with Powerflex bushes?
Thanks for any advice!
D
#2
Scooby Regular
iTrader: (2)
Join Date: May 2000
Location: Class record holder at Pembrey Llandow Goodwood MIRA Hethel Blyton Curborough Lydden and Snetterton
Posts: 8,626
Likes: 0
Received 0 Likes
on
0 Posts
It should be a doddle.
I replaced a rear ARB last weekend and I am assuming the front ARB is fitted the same way.
The bracket is held on by one bolt, the other side clips into a slot. The bush to go on should have a slice through it so that it can be opened out and clipped over the ARB. Then refit the bracket. Dead simple (well, for the rear anyway )
Justin
I replaced a rear ARB last weekend and I am assuming the front ARB is fitted the same way.
The bracket is held on by one bolt, the other side clips into a slot. The bush to go on should have a slice through it so that it can be opened out and clipped over the ARB. Then refit the bracket. Dead simple (well, for the rear anyway )
Justin
#3
Looked like that on the front mountings too mate - that just leaves the size issue now! It could be 19mm or 22mm and I do not have a micrometer to check! Anyone any ideas? Cheers
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
ATWRX
Full Cars Breaking For Spares
88
01 February 2016 07:28 PM