Alignment done with Prodrive settings - Please advice
Thread Starter
Scooby Regular
Joined: Jul 2005
Posts: 180
Likes: 0
From: Bedford
Alignment done with Prodrive settings - Please advice
Just had alignment done after new tyres on MY05WRX with standard springs.
These were the settings I wanted.
Front Camber -1°15’ (-1.25°)
Front Toe Total 0°00’ (0.00°)
Rear Toe 0°06’ (0.1°) per wheel toe in [0°12’ (0.2°) total toe in]
Front R wheel camber could not be set to -1°15’ and with maximum effort it went to -0°59'
The remaining 3 corners are now set up as above. Please advice as to whether I should leave them at this or change them again (perhaps by using (whiteline) camber bolts).
P.S. : car is handling better than previous factory settings.
These were the settings I wanted.
Front Camber -1°15’ (-1.25°)
Front Toe Total 0°00’ (0.00°)
Rear Toe 0°06’ (0.1°) per wheel toe in [0°12’ (0.2°) total toe in]
Front R wheel camber could not be set to -1°15’ and with maximum effort it went to -0°59'
The remaining 3 corners are now set up as above. Please advice as to whether I should leave them at this or change them again (perhaps by using (whiteline) camber bolts).
P.S. : car is handling better than previous factory settings.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
Oct 22, 2015 06:12 AM
johnnybon
Wheels And Tyres For Sale
7
Sep 25, 2015 07:49 AM