Alignment done with Prodrive settings - Please advice
 

Just had alignment done after new tyres on MY05WRX with standard springs.
These were the settings I wanted.

Front Camber -1°15’ (-1.25°)
Front Toe Total 0°00’ (0.00°)
Rear Toe 0°06’ (0.1°) per wheel toe in [0°12’ (0.2°) total toe in]

Front R wheel camber could not be set to -1°15’ and with maximum effort it went to -0°59'

The remaining 3 corners are now set up as above. Please advice as to whether I should leave them at this or change them again (perhaps by using (whiteline) camber bolts).

P.S. : car is handling better than previous factory settings.:D