which suspension????
#2
How far do you want to go?
Fast(er) road
Semi track
***** out racer?
Assuming the first, the 'standard' method is(assuming DIY fit)
Whiteline rear antiroll bar (22mm)
Solid rear links for above
ALK for the front wishbones
Camber bolts all round
Noltek top front mounts if you have a bit of cash (if so delete the ALK and front camber bolts)
Ebach 20mm lowering springs (assuming your current dampers are ok)
Good alignment job (ie Powerstation Andy or Curtis + bump steer mod)
Decent tyres (!)
All that lot done and the car will be superb.
To get to ***** out racer will cost about another £1500 on top....
Hope that helps.
Lots of people have done the above (I'm at the near ***** out bit) and smile around every corner.
Graham
My standard calling card:
http://jusspress.com/daymainframe.ph...102&imageNum=3
Fast(er) road
Semi track
***** out racer?
Assuming the first, the 'standard' method is(assuming DIY fit)
Whiteline rear antiroll bar (22mm)
Solid rear links for above
ALK for the front wishbones
Camber bolts all round
Noltek top front mounts if you have a bit of cash (if so delete the ALK and front camber bolts)
Ebach 20mm lowering springs (assuming your current dampers are ok)
Good alignment job (ie Powerstation Andy or Curtis + bump steer mod)
Decent tyres (!)
All that lot done and the car will be superb.
To get to ***** out racer will cost about another £1500 on top....
Hope that helps.
Lots of people have done the above (I'm at the near ***** out bit) and smile around every corner.
Graham
My standard calling card:
http://jusspress.com/daymainframe.ph...102&imageNum=3
Last edited by 911; 02 November 2005 at 09:07 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM