RiSKy

Got some last weekend for my 95 wrx (front 19mm??) had ago at fittimg them yesterday and thier smaller (width) than the existing rubber bushes. Have i got the wrong ones??

Roy

Hol

iTrader: (1)

Get a 19mm open ended spanner and fit it over your ARB, if its snug your roll bar is 19mm, if not and it dont fit over, then youve got a bigger one and need to find a 20 and 22mm spanner.

I fitted these bushes to my TypeR and used the spanner technique to check the ARB sizes. You can do both without jacking up the car, just put the front wheels on full lock.

RiSKy

Thanks Hol, that makes almost too much sence the bar is a 19mm. Phoned Powerflex and after a bit of head scratching they found a wider 19mm aplication should get the replacements next week. I'll post the part no.s next week if there right.

Roy

RiSKy

The replacement bushes arived last week, but they turned out to be for new age cars (01>) i've sent them back for a refund!!

Roy, any ideas

Hol

iTrader: (1)

Ill dig out the boxes and let you know the numbers for my STI 98.

Ill also send you my old ones, if you mail me an address as there was nothing wrong with them and you could always send them off for powerflex to match, if they fit.

RiSKy

Thanks Hol, that'll be cool!! even if they turn out like the first ones i tried, it'll give me some spares to use while i sort out some replacements.

i'll send you a pm tomorrow, at work now

Roy

RiSKy

Hol, sent you mail.

Thanks, Roy