Autronic ecu
14 December 2013, 07:16 PM
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: May 2003
Location: TTS
Posts: 561
Likes: 0
Received 0 Likes
on
0 Posts
Autronic ecu
Autronic ecu with launch control and anti lag to fit my97-98 cars (phase 1.5 with coil pack in the centre of inlet manifold) comes with inlet temp sensor and cable for mapping.
Originally supplied, fitted and mapped by Scoobyclinic about 5 years ago at a cost of £1700
Since been mapped by Andy Forrest
Looking for £500?
Originally supplied, fitted and mapped by Scoobyclinic about 5 years ago at a cost of £1700
Since been mapped by Andy Forrest
Looking for £500?
18 January 2014, 02:20 PM
#5
Scooby Regular
iTrader: (3)
Join Date: Nov 2011
Location: Ireland
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
I bought this for my ver 3/4, 3 plug, "the one with the coil pack in the middle" as per the add.... guess what... its for a ver 1/2, 4 plug individual coils..
Any chance of a refund steve? this no good to me.
Regards Eric.
Any chance of a refund steve? this no good to me.
Regards Eric.
18 January 2014, 04:25 PM
#6
Scooby Regular
iTrader: (61)
Join Date: Aug 2005
Location: N.I
Posts: 3,444
Likes: 0
Received 0 Likes
on
0 Posts
Eric just for reference the Autronic for version 3/4 has 4 sockets as per version 1/2 but only 3 of them are used. I recently removed and sold mine and was mighty confused when I looked at it.
Last edited by scubbay; 18 January 2014 at 04:27 PM.
Trending Topics
21 January 2014, 10:16 PM
#9
Scooby Regular
iTrader: (3)
Join Date: Nov 2011
Location: Ireland
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
Scubbay you were dead right, 4 plugs but only 3 used, my apology's steve for jumping the gun.
as this ecu runs maffless I will be changing the inlet set up, what did you guys do with your idle valve set up? small filter straight on to it? no need to plumb it back to inlet pipe now... have even seen a ver 1 with this ecu with the icv removed altogether! with a blanking plate bolted in
any ideas people?
as this ecu runs maffless I will be changing the inlet set up, what did you guys do with your idle valve set up? small filter straight on to it? no need to plumb it back to inlet pipe now... have even seen a ver 1 with this ecu with the icv removed altogether! with a blanking plate bolted in
any ideas people?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM