euan_r

iTrader: (29)

hi i have the following for sale bought to fix my 304mm setup temporarily that uses same cp5200 calipers but my ap kit has caliper machined slightly so no use.

heres original advert blatantly pinched:

Just got the calipers back from Alyn at AS Performance after a rebuild from a leaky seal. The bleed nipples, knock back springs, half caliper bolts and seals are all new as supplied buy Alyn last year. The car did less than 5000 miles on these and no miles since rebuild.


This setup includes:
2x AP CP5200 4 pot calipers
2x Alloy brackets c/w retaining nuts and bolts
4x Caliper retaining hex cap bolts
4x PF08 compound pads which I have cleaned extensively since the small fluid leak and still look like they have no wear at all

I can also supply the 330mm godspeed rotors and bells that came with the kit when I purchased it from Wuz - these have seen better days and ideally could be replaced.

£550 +p&p

Fronts showing the new nipples, pads and knock back clip.


Rears showing brackets and bolts, note I've also fitted the four nipple caps.


and the rotors and bells

euan_r

iTrader: (29)

Bttt

makkink

Can you fit these also on the rear of a sti type-r?

euan_r

iTrader: (29)

No, as there is no provision for handbrake. dont know if they would line up for hydraulic handbrake.

crazyspeedfreakz

iTrader: (92)

Hi would these perform against brembo & ksport, I am in the market for a decent set
Up, these are not exactly what I was looking for but could be intrested..

Cheers

euan_r

iTrader: (29)

I havent used this set but ap calipers are a lot better than k sports without dust seals near end of bore on caliper wall, im led to believe the brembos retain heat a good bit too.

I run smaller 304mm ap kit with pagid grays and they are fantastic.