2.5 block casings and crankshaft.
03 October 2012, 10:12 PM
#1
Scooby Regular
Thread Starter
iTrader: (35)
Join Date: Nov 2006
Posts: 2,784
Likes: 0
Received 0 Likes
on
0 Posts
2.5 block casings and crankshaft.
As title, I have a pair of 2.5 engine cases which are on standard bore.
The bores have been cleaned up with a light hone from the machine shop, and have had the headgasket faces cleaned up to ensure a good mating face.
They have had 0.1mm taken off them.
The crank is in good condition, and the engine was running perfectly before it was stripped down.
New bearings would be recommended, although the existing ones are present.
£500.00 delivered anywhere in the UK.
The bores have been cleaned up with a light hone from the machine shop, and have had the headgasket faces cleaned up to ensure a good mating face.
They have had 0.1mm taken off them.
The crank is in good condition, and the engine was running perfectly before it was stripped down.
New bearings would be recommended, although the existing ones are present.
£500.00 delivered anywhere in the UK.
Thread
Thread Starter
Forum
Replies
Last Post
bluebullet29
General Technical
9
05 October 2015 02:17 PM