Ok so I bought this recently without knowing that the hole for the
Lambda sensor had been closed up,
as u can see from the pics
It's a 3" down to 2 nd a half where meets with center section also
I'm sure u can all tell its a bell mouth





£65 collected

 

Might be slightly overpriced new price

£50 collected.

 

Upppskiii

 

Offers considered !

 

Up!!

 

Why not spend £10-20 and get a lambda boss welded on??
Any exhaust specialist like Longlife/Powerflow would be able to do it, or any welder who can weld stainless.

 

Any idea on what size it is I can see a few on eBay ?

 

Upppp

 

£45 collected ...?

 

Where about are u mate

 

If you need a 3" stainless steel one to replace it with i have one to hand 6 months old £70

 

Based in Surrey bud .... Send us a pm I need to sell ASAP to fund new parts maybe we can work out a price ...

Cheers

 

Up

 

Uppppp

 

Whats the cheapest u will go posted 2 suffolk?

 

Pm sent

 

All lambda bosses are the same thread iirc, so just chop off the one there and get it welded on. Most exhaust companies would carry that sort of boss in stock.

If not this would do the job, once welded on.

http://www.ebay.co.uk/itm/Stainless-...9#ht_500wt_969

Looking at yours you may be able to remove the plate on the top, and the threaded boss should be underneath. Only looks like a patch welded ontop of the boss, to block it off.

 

That's what I was thinking but was unsure, what's the best way to remove the cap ... Do I need to get it heated up ? To see if the boss is good ?

 

Cut it off with a disk cutter, just the weld on the plate, if the thread is goosed (or you destroy it by accident) then you will need a new boss, but they aren`t expensive.

 

New boss ordered