Classic downpipe
Ok so I bought this recently without knowing that the hole for the
Lambda sensor had been closed up, as u can see from the pics It's a 3" down to 2 nd a half where meets with center section also I'm sure u can all tell its a bell mouth http://i905.photobucket.com/albums/a...z/9a406070.jpg http://i905.photobucket.com/albums/a...z/9452cbc9.jpg £65 collected :thumb: |
Might be slightly overpriced new price
£50 collected. |
Upppskiii
|
Offers considered !
|
Up!!
|
Why not spend £10-20 and get a lambda boss welded on??
Any exhaust specialist like Longlife/Powerflow would be able to do it, or any welder who can weld stainless. |
Originally Posted by Jimbob
(Post 10421688)
Why not spend £10-20 and get a lambda boss welded on??
Any exhaust specialist like Longlife/Powerflow would be able to do it, or any welder who can weld stainless. |
Upppp
|
£45 collected ...?
|
Where about are u mate
|
If you need a 3" stainless steel one to replace it with i have one to hand 6 months old £70
|
Originally Posted by littlebit
(Post 10425659)
Where about are u mate
Based in Surrey bud .... Send us a pm I need to sell ASAP to fund new parts maybe we can work out a price ... Cheers |
Up
|
Uppppp
|
Whats the cheapest u will go posted 2 suffolk?
|
Originally Posted by davewagonwrx
(Post 10427318)
Whats the cheapest u will go posted 2 suffolk?
|
Originally Posted by crazyspeedfreakz
(Post 10421879)
Any idea on what size it is I can see a few on eBay ?
If not this would do the job, once welded on. http://www.ebay.co.uk/itm/Stainless-...9#ht_500wt_969 Looking at yours you may be able to remove the plate on the top, and the threaded boss should be underneath. Only looks like a patch welded ontop of the boss, to block it off. |
Originally Posted by Jimbob
(Post 10427468)
All lambda bosses are the same thread iirc, so just chop off the one there and get it welded on. Most exhaust companies would carry that sort of boss in stock.
If not this would do the job, once welded on. http://www.ebay.co.uk/itm/Stainless-...9#ht_500wt_969 Looking at yours you may be able to remove the plate on the top, and the threaded boss should be underneath. Only looks like a patch welded ontop of the boss, to block it off. |
Originally Posted by crazyspeedfreakz
(Post 10427861)
That's what I was thinking but was unsure, what's the best way to remove the cap ... Do I need to get it heated up ? To see if the boss is good ?
|
Originally Posted by Jimbob
(Post 10428153)
Cut it off with a disk cutter, just the weld on the plate, if the thread is goosed (or you destroy it by accident) then you will need a new boss, but they aren`t expensive.
New boss ordered :thumb: |
All times are GMT +1. The time now is 01:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands