This will/should get nuked I'm sure, but here goes

If you're using a Syvecs and need a few more inputs and fancy some GPS and acceleration sensors, this might be of interest

It's a new I/O expander:

• 4 inputs with configurable pull-up resistors, suitable for all sensor types; capable of speed measurement (e.g. for ABS wheel speed sensors).
• H-bridge output which can be configured as a single full bridge or two independent half bridges. Suitable for drive-by-wire throttle control, for example, or DCCD etc.
• 25Hz update-rate GPS receiver, providing accurate “RADAR” vehicle speed
• Bosch LSU 4.9/4.2 lambda amplifier with PID heater control
• Single channel K-type thermocouple amplifier
• Barometric pressure sensor
• Triple axis accelerometer, for vertical, lateral and longitudinal G measurement
• Triple axis G sensors, for roll, pitch and yaw measurement

 

can this be used to control dccd

 

No it's purely an expansion unit for the Stvecs ECU