THROTTLE CABLE . . .
#1
THROTTLE CABLE . . .
How many of you have ever bothered checking its connection to the throttle pully, in the engine bay? Not many, I bet? I can imagine it's often overlooked, no?
I was sorting out my IAVC the other day, and whilst in there noticed that the throttle cable was well slack. So much so, it was actually sagging - a bit like a skipping rope lol.
So naturally, I readjusted it to a point where it was just slacked off from actually pulling on and turning the pulley. The inner cable is now poker-straight, but there is still about 3mm (recommended) slack when you hook your finger around it and push/pull on it vertically. Much better.
I also liberally sprayed all the moving parts of the pulley assembly with some PlusGas.
I was sorting out my IAVC the other day, and whilst in there noticed that the throttle cable was well slack. So much so, it was actually sagging - a bit like a skipping rope lol.
So naturally, I readjusted it to a point where it was just slacked off from actually pulling on and turning the pulley. The inner cable is now poker-straight, but there is still about 3mm (recommended) slack when you hook your finger around it and push/pull on it vertically. Much better.
I also liberally sprayed all the moving parts of the pulley assembly with some PlusGas.
Last edited by joz8968; 28 August 2016 at 03:34 PM.
Thread
Thread Starter
Forum
Replies
Last Post
The Rig
Engine Management and ECU Remapping
42
17 March 2017 07:26 PM
MattyB1983
Subaru Parts
5
12 June 2016 10:29 PM
stamina_daddy
Engine Management and ECU Remapping
3
09 June 2016 10:57 AM