2008 Hatch STI Enginetuner 2.35 stroker w/563bhp
#1
2008 Hatch STI Enginetuner 2.35 stroker w/563bhp
MY08 Subaru Impreza WRX STi Type Uk in Spark Silver
Enginetuner built 2.35 stroker using
•EJ22T CDB with rear thrust conversion
•Mahle pistons
•Cosworth Rods
•Subaru Nitrided Crank
•ACL Race bearings
RCM 14mm Head stud kit
Cosworth Head Gaskets
Cylinder head conversion including cosworth +1mm inconel valves
RCM twisted uppipe and downpipe turbo kit heat wrapped
RCM oil feed kit
RCM oil drain kit
RCM water pipe kit
RCM 12mm Oil pump
Cotters
RCM Fuel Rails
GT30 Billet Plus Turbo
Tial wastegate
Syvecs S6PNP ECU with Hatch Loom
High/Med/Low boost maps by MartynJ @ Enginetuner
Toucan Touchscreen display unit with sensors for oil pressure/temp, fuel pressure, air charge temperature, wideband lambda
DW 1300cc injectors
RCM Intake hose
RCM Outlet hose
RCM Trumpet
RCM Air filter
Exedy Hyper Twin Plate Clutch kit inc. Flywheel
Cosworth Sump baffle plate
RCM Ceramic Coated Headers
Perrin Front Mount Intercooler
Perrin Aux Belt Guard
Perrin Radiator Shroud
Perrin Radiator Stays
Bosch 044 Secondary Fuel Pump
Swirl pot
Mocal Catch Tank with RCM return to sump system
3" Jetex CatBack Exhaust
Litchfield Imports 2011 Type-20 Chassis package including the following:
•Whiteline rear anti roll bar
•Power steering pump revalve for better feel
•4 Wheel laser alignment with fast road settings
•Revised sub frame and chassis bush kit
•Litchfield Front Strut Brace
•AST adjustable dampers with 2011 Type-20 internals
•AST adjustable top mounts
•Whiteline front anti roll bar
Rota G-Force 18x8.5 Alloy Wheels refurb'd in gloss black
Vredestein ultra sessanta Tyres
McGuard STI Locking wheel nuts
D2 356mm 8pot Big brake kit (to be fitted)
This vpower only @ 2.0bar
TAX till AUGUST 2014
MOT till JUNE 2014
45000 miles (only 4500 miles done on rebuilt 2.35 engine)
Loads of receipts, I have probably spent £25k on modifications for this car in the last 12 months alone.
Bad bits
Car is a daily driver for the family, hence I am not advertising it as mint condition. Personally I think it needs the rear bumper, roof and bonnet sprayed and some pdr work to make it perfect. None of the problems are easily noticeable, but I am just being honest and don't want any hidden surprises. Rear bumper has a small scuff, and a crack in the paint from over flexing the bumper. Roof has a tiny pin head rust spot from a stone chip that I think needs stripping back and repairing, and some spotting in the paint from what looks like a smart repair (must have been done by dealer before I purchased it). Bonnet has several stone chips. Cruise control isn't functional due to syvecs ecu. Key light on dash stays permanently on, also due to syvecs ecu (eventually an update to the ecu may become available to fix both issues)
For a lot more info on the car, check out my project thread here:
https://www.scoobynet.com/projects-4...ner-style.html
Why am I selling?
Time to grow up....I need to get on the property ladder, sick of paying somebody else's mortgage.
I would love to see someone take this project on and continue the project thread. Maybe strip it and turn it into a track car, all the kit is there
I am looking for £21,500ono
It's probably worth more than the asking price if someone had the time to break into parts.
Any questions or more pictures required feel free to ask.
You can either pm on here or email jay@stivescornwall.net
or for serious offers tel: 07876440568
Enginetuner built 2.35 stroker using
•EJ22T CDB with rear thrust conversion
•Mahle pistons
•Cosworth Rods
•Subaru Nitrided Crank
•ACL Race bearings
RCM 14mm Head stud kit
Cosworth Head Gaskets
Cylinder head conversion including cosworth +1mm inconel valves
RCM twisted uppipe and downpipe turbo kit heat wrapped
RCM oil feed kit
RCM oil drain kit
RCM water pipe kit
RCM 12mm Oil pump
Cotters
RCM Fuel Rails
GT30 Billet Plus Turbo
Tial wastegate
Syvecs S6PNP ECU with Hatch Loom
High/Med/Low boost maps by MartynJ @ Enginetuner
Toucan Touchscreen display unit with sensors for oil pressure/temp, fuel pressure, air charge temperature, wideband lambda
DW 1300cc injectors
RCM Intake hose
RCM Outlet hose
RCM Trumpet
RCM Air filter
Exedy Hyper Twin Plate Clutch kit inc. Flywheel
Cosworth Sump baffle plate
RCM Ceramic Coated Headers
Perrin Front Mount Intercooler
Perrin Aux Belt Guard
Perrin Radiator Shroud
Perrin Radiator Stays
Bosch 044 Secondary Fuel Pump
Swirl pot
Mocal Catch Tank with RCM return to sump system
3" Jetex CatBack Exhaust
Litchfield Imports 2011 Type-20 Chassis package including the following:
•Whiteline rear anti roll bar
•Power steering pump revalve for better feel
•4 Wheel laser alignment with fast road settings
•Revised sub frame and chassis bush kit
•Litchfield Front Strut Brace
•AST adjustable dampers with 2011 Type-20 internals
•AST adjustable top mounts
•Whiteline front anti roll bar
Rota G-Force 18x8.5 Alloy Wheels refurb'd in gloss black
Vredestein ultra sessanta Tyres
McGuard STI Locking wheel nuts
D2 356mm 8pot Big brake kit (to be fitted)
This vpower only @ 2.0bar
TAX till AUGUST 2014
MOT till JUNE 2014
45000 miles (only 4500 miles done on rebuilt 2.35 engine)
Loads of receipts, I have probably spent £25k on modifications for this car in the last 12 months alone.
Bad bits
Car is a daily driver for the family, hence I am not advertising it as mint condition. Personally I think it needs the rear bumper, roof and bonnet sprayed and some pdr work to make it perfect. None of the problems are easily noticeable, but I am just being honest and don't want any hidden surprises. Rear bumper has a small scuff, and a crack in the paint from over flexing the bumper. Roof has a tiny pin head rust spot from a stone chip that I think needs stripping back and repairing, and some spotting in the paint from what looks like a smart repair (must have been done by dealer before I purchased it). Bonnet has several stone chips. Cruise control isn't functional due to syvecs ecu. Key light on dash stays permanently on, also due to syvecs ecu (eventually an update to the ecu may become available to fix both issues)
For a lot more info on the car, check out my project thread here:
https://www.scoobynet.com/projects-4...ner-style.html
Why am I selling?
Time to grow up....I need to get on the property ladder, sick of paying somebody else's mortgage.
I would love to see someone take this project on and continue the project thread. Maybe strip it and turn it into a track car, all the kit is there
I am looking for £21,500ono
It's probably worth more than the asking price if someone had the time to break into parts.
Any questions or more pictures required feel free to ask.
You can either pm on here or email jay@stivescornwall.net
or for serious offers tel: 07876440568
Last edited by jaypSTi; 19 February 2014 at 07:34 PM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Car Parts For Sale
1
18 November 2015 07:49 AM