how do blobeye sti foglight covers come out?
11 September 2008, 07:52 PM
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Sep 2003
Location: gravesend, kent
Posts: 4,721
Likes: 0
Received 0 Likes
on
0 Posts
how do blobeye sti foglight covers come out?
rather than doing my usual of missing the one clip that's holding something on and then breaking it i thought i'd do a bit of homework.
so are there any more clips than in this pic? (stolen pic off ebay)
and do you just slide a thin blade/screwdriver in and push the clips up/down to release them?
any advice much appreciated
cheers, Paul
so are there any more clips than in this pic? (stolen pic off ebay)
and do you just slide a thin blade/screwdriver in and push the clips up/down to release them?
any advice much appreciated
cheers, Paul
11 September 2008, 11:02 PM
#2
Scooby Regular
iTrader: (3)
Join Date: Feb 2007
Location: Inverness
Posts: 743
Likes: 0
Received 0 Likes
on
0 Posts
Easy job and takes seconds. Use a flat bladed screwdriver or similar and gently prise out the bottom or top then get you fingers in behind. Pop the innermost part off first (nearest the grille) then work your way back the other side. The long clip bit you see will be the last bit to pop out, give it a gentle wiggle up and down whilst pulling and there you go. Easy.
12 September 2008, 06:16 AM
#3
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Sep 2003
Location: gravesend, kent
Posts: 4,721
Likes: 0
Received 0 Likes
on
0 Posts
Easy job and takes seconds. Use a flat bladed screwdriver or similar and gently prise out the bottom or top then get you fingers in behind. Pop the innermost part off first (nearest the grille) then work your way back the other side. The long clip bit you see will be the last bit to pop out, give it a gentle wiggle up and down whilst pulling and there you go. Easy.
cheers for the reply
