WRX MESH GRILL
Do your own with a piece of mesh from Halfrauds etc, about £11 buys enough to do upper and lower grilles.
It was cut by trial and error, taking off tiny bits at a time until it fit. Cut using good kitchen scissors......at least they WERE good
:
Mine is done with black alloy mesh, and held in place with small zip ties, or twisted copper enamel wire, either of which is invisible from normal viewing distances.
The beauty of it is, the original grille is still there if you ever want to put it back to standard.
Alcazar
It was cut by trial and error, taking off tiny bits at a time until it fit. Cut using good kitchen scissors......at least they WERE good
:Mine is done with black alloy mesh, and held in place with small zip ties, or twisted copper enamel wire, either of which is invisible from normal viewing distances.
The beauty of it is, the original grille is still there if you ever want to put it back to standard.
Alcazar
That's correct.
Once you've bought the mesh of your choice, stand it against a wall, stand back from it, and then repeat with it the other way up.
Decide which effect you like best, and make sure that each piece is cut with it that way round.
Alcazar
Once you've bought the mesh of your choice, stand it against a wall, stand back from it, and then repeat with it the other way up.
Decide which effect you like best, and make sure that each piece is cut with it that way round.
Alcazar
Scooby Regular
Joined: Aug 2003
Posts: 437
Likes: 0
From: devon
try MRO styling m8 just ordred a front grill and airdam they look the biz and the sites goyt some good pics 2 ogle over.www.mroscoobystyling.com
will get mine in a weeks time after fitting ill try and post some picks of it.
will get mine in a weeks time after fitting ill try and post some picks of it.
Thread
Thread Starter
Forum
Replies
Last Post