Fog Cover clip alternate solution
#1
Scooby Regular
Thread Starter
Well
After trawling all round Wigan this morning to try and find some clips that I could use to hold my Fog Covers on, I may have the perfect (or as near as) solution, at least for the top two clips
I looked at the holes, and looked at what I could use, and sat looking straight at me, was a blanking plate from a PC, the ones from the back, where you add additional cards etc
Well I took this, went out to the car, and it is a perfect very snug fit
So when I get a bit more time, im going to screw a couple of these to the tops of my Fog Covers
And then I can just slide them straight into the holes already in the bumper
I should be able to put a slit hole in the bottom recess, and do excatly the same there
Nice one
After trawling all round Wigan this morning to try and find some clips that I could use to hold my Fog Covers on, I may have the perfect (or as near as) solution, at least for the top two clips
I looked at the holes, and looked at what I could use, and sat looking straight at me, was a blanking plate from a PC, the ones from the back, where you add additional cards etc
Well I took this, went out to the car, and it is a perfect very snug fit
So when I get a bit more time, im going to screw a couple of these to the tops of my Fog Covers
And then I can just slide them straight into the holes already in the bumper
I should be able to put a slit hole in the bottom recess, and do excatly the same there
Nice one
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sub-Subaru
General Technical
1
28 September 2015 12:47 PM