Sigma M32 Problem
Thread Starter
Scooby Newbie
Joined: Dec 2008
Posts: 1
Likes: 0
Sigma M32 Problem
Hi All,
can any one help, My alarm has been going off randomly so I purchased a keypad for it to diagnose fault and change settings, is there anything I need to do to enable the keypad?? none of the programming codes do anything and the light on the keypad flashes either once or several times when pressing. I have tried again and again following the instructions to the letter but no joy
I have looked at several other posts/sites and am told the codes are the same as the M30. can anyone shed any light on the problem ?
Any help much appreciated
Thanks
Webswalks
can any one help, My alarm has been going off randomly so I purchased a keypad for it to diagnose fault and change settings, is there anything I need to do to enable the keypad?? none of the programming codes do anything and the light on the keypad flashes either once or several times when pressing. I have tried again and again following the instructions to the letter but no joy
I have looked at several other posts/sites and am told the codes are the same as the M30. can anyone shed any light on the problem ?Any help much appreciated
Thanks
Webswalks
Scooby Regular
Joined: Sep 2007
Posts: 497
Likes: 6
From: belfast
Hi All,
can any one help, My alarm has been going off randomly so I purchased a keypad for it to diagnose fault and change settings, is there anything I need to do to enable the keypad?? none of the programming codes do anything and the light on the keypad flashes either once or several times when pressing. I have tried again and again following the instructions to the letter but no joy I have looked at several other posts/sites and am told the codes are the same as the M30. can anyone shed any light on the problem ?
Any help much appreciated
Thanks
Webswalks
can any one help, My alarm has been going off randomly so I purchased a keypad for it to diagnose fault and change settings, is there anything I need to do to enable the keypad?? none of the programming codes do anything and the light on the keypad flashes either once or several times when pressing. I have tried again and again following the instructions to the letter but no joy
I have looked at several other posts/sites and am told the codes are the same as the M30. can anyone shed any light on the problem ?Any help much appreciated
Thanks
Webswalks
Last edited by big-kev; Dec 30, 2008 at 05:33 PM.
Thread
Thread Starter
Forum
Replies
Last Post