got this fitted on my P1 went to start it last night got no ignition but car locks and unlocks fine!?
ignition comes on when i press the turbo timer button and car starts fine only for the 40 secs the timers timed up for!?

ive checked all the ignition wires on the barrall all wires are powering as should be! but as i turn the key no ignition?

anyone know much about these or how i can by pass it thanks!!!

 

if you don't start the car within 30 seconds of disarming you won't be beable to start it.

Sounds like the alarm imm has cut in.

 

yeah i know ive only got little time to start it but just nothing there as soon as i go to?!

just funny how it allows to put the ignition on when i press the turbo timer button and not when i unlock it to keep it on to start the car?

 

sounds like a bad connection at the turbo timer relay. probably pin 87

 

are you sure blackjaxx isnt enabled?

 

all sorted now! well sort of! it was the imboliser at fault so bypassed and all good now!
they recon it is strange for it to just stop working the way it did and it could have been caused by not having the alarm in valet mod when i had the battery disconnected and when put back on i spiked the system!?!

 

that wouldn't cause it.........

not had a faulty immobiliser point on one of them for a long time. must be just your luck

 

as Jesus said i aint had an immobilizer issue really b4 on my concept 650, but i have had issue with the keypad kickin in! u can find all info on how to conrol your alarm in the pdf files at Clifford - Vehicle Security | Remote Start | GPS Tracking goto the products links and u should find the user/installlation pdfs there, hope this helps, nowt worse than buying a car without alarm instructions