axgt_bwaii

iTrader: (6)

its worked fine since i got the car 4 months ago (alarm allready fitted) but lately its been playing up. it allways unlocks fine with the fob but when locking it sometimes it makes the wrong tone. it beeps diffirently to what it should do. even does this if i open and shut all the doors, boot and bonnet. after the wrong beep the alarm will go off in say 5 seconds but it still locks tho????

Scoob+Bike=Fun

dodgy boot/bonnet sensor, ultrasonics/microwave/trapped wire after the alarm has gone off, the led should give you a series of flashes, which in turn relates to which sensor is dodgy. hopefully this should get you in the right direction.

axgt_bwaii

iTrader: (6)

ok ill start to watch the led to see if i can catch it out and report it here. how bloody anoying tho. if i leave the engine off for like 15 secs the imobiliser kicks in so i have to lock then un lock to start up again. not funny for me when im tryna look kewl in da scooby buying petrol and the fu***r goes off!!!! funny for others tho............................................... ......................................

155mph to slow

It might be because the battery is going flat in the remote. Have you checked your owners manual?

p@ul

You dont have to lock then unlock again when its imobilised you just put key in ignition to to on possition and press the pad once m8 your ignition lights come back on and you turn the key

axgt_bwaii

iTrader: (6)

ow

its still being an pain. ive swaped the battery and its the same. been locking the car with the key. thing is sometimes when i do get it to lock from the fob the alarm goes off seconds after even when it makes the right tone!

stew

wannaB4

look under the bonnet and find the pin switch (normally on the slam panel somewhere) there will be a spade terminal connected to it underneath, try pulling it off and leaving it off for a day or so to see if you still get the problem, with the rain and crap weather it could be a bit of water on it. Or you could sit in the car, hold down the blank button on the valet switch, arm them disarm, the led will then start to flash count the number of flashes (eg... flash.flash......flash.flash......flash.flash..... ....etc etc) this will tell you what is triggering the alarm. Post results here if you need to know more.

axgt_bwaii

iTrader: (6)

well **** me m8. thats what its for! the button thingy next to the rear fog light. if you wouldnt mind please could you explain what its for? why its there and what i need to do?

stew

wannaB4

read here ( http://clifford.com/guides/ogs/concept300uk_owners.pdf ) page 11.

axgt_bwaii

iTrader: (6)

thats realy handy m8 thanks. priceless info there.

stew