Relay on clifford negative out
#1
I want to attach a relay on a spare output channel, the alarm outputs a negative out when the channel is activated. So to get this to operate the relay do I hang the 12v on the other side thus when activation the circuit is complete and relay is activated....or have I got this completely wrong ?
#2
The terminals on the relay should be numbered.
85 - Neg out from alarm
86 - +12v
30 - + or - , depending on what you are switching. Whatever is on here will come out of 87 when relay is activated
87 - Whatever is on pin 30 will be here when relay is switched
87a - Whatever is on 30 will be here when relay is at rest
85 - Neg out from alarm
86 - +12v
30 - + or - , depending on what you are switching. Whatever is on here will come out of 87 when relay is activated
87 - Whatever is on pin 30 will be here when relay is switched
87a - Whatever is on 30 will be here when relay is at rest
#6
Don't forget to put a shunt diode on the relay.
As wannaB4 has instructed to you to wire it up in that way, put the band side of the diode to pin 86(+12v) and the other side to pin 85(-).
Best to solder the diode to the terminals prior to connecting the terminals.
Martin
As wannaB4 has instructed to you to wire it up in that way, put the band side of the diode to pin 86(+12v) and the other side to pin 85(-).
Best to solder the diode to the terminals prior to connecting the terminals.
Martin
Thread
Thread Starter
Forum
Replies
Last Post
DogsofWar
Engine Management and ECU Remapping
16
23 September 2015 07:41 PM