Fitting lock motor to MY95
#1
Hi
Does anyone have instructions/pictures of how a lock motor is fitted to the drivers door of a MY95 so I can add central locking to my car? I'm fine with the wiring, I just need to see where to fit it and what to attach it to.
Thanks
Matthew
Does anyone have instructions/pictures of how a lock motor is fitted to the drivers door of a MY95 so I can add central locking to my car? I'm fine with the wiring, I just need to see where to fit it and what to attach it to.
Thanks
Matthew
#2
Once you've opened the driver's door up, you'll notice a rod from the lock switch in the door handle which goes horizontally to the rear end of the door where it is clipped to a mechanism which transfers it's push/pull action to a vertical rod. Mount the lock motor in the bottom corner of the door pointing vertically upward and connect the metal rod in the kit with your motor to the plunger on the motor and clamp it to the vertical subaru rod so that your motor is able to push and pull on this rod.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM