Morning!
Am trying to add a fob to my toad but cannot get to the bit where you add the pin code. Starting from the disarmed state and after switching the ignition on for the 3rd time (within 7 secs), the status LED remains "off". At this point, according to the manual, we should see a fast flashing LED. Alarm works fine otherwise, but I cannot get the control unit to enter 'program mode'. Any suggestions would be welcome. Thanks

 

Tell me if you get in close the doors and put ignition on do the doors lock after abourt 20 seconds ?

 

Hey mr toad, need to speak with you regarding fitting a cat 1 or repair/investigate current one please

 

Thanks for the reply. They do indeed lock after trying the ignition sequence.

 

Ok no probs ring me 07774 446402

Ian

 

Then the alarm is seing the ignition ring me tomoro 07774 446402

Ian

 

Will do but car getting built so will contact after that.

 

Hi Ian, I am back at this little problem again - missed you a couple of times there. When is a good time for me to call you please?