Shortyturbo

I have just fitted a Toad Sterling One which is basically a Toad AI606 with less outputs to my 99 type r.
Alarm is working perfectly but I am now confused as to how to connect to the central locking circuit.
The (white/ silver dots) wire going to the central locking control module unlocks doors when earthed and locks when earth disconnected.

So all I want is the alarm to make circuit to open and break circuit when locked.
Surly there is an easy way of doing this, the installation instructions are not helping and not sure if I need a relay or how to connect.

Shortyturbo

Got it sorted in the end. Not the way I was planning but does the job perfectly.

fitted a solenoid in drivers door,

wired 2 relays to reverse polarity from negative pulse,

connected alarm to give a negative pulse to relays for lock and unlock.

This replaces the action of the key in door and so passenger door and boot are opened at same time.

MR_TOAD_INSTALLER

iTrader: (1)

Instructions for locking diagram is in there

Shortyturbo

Yeah I used the negative pulse diagram in end,
I was just expecting to connect the alarm to the central locking directly and wire the drivers motor into the central locking control unit with the passenger motor