Hawk into a blob dash
#1
Scooby Regular
Thread Starter
Join Date: Jan 2012
Location: Southam, Warwickshire
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
Hawk into a blob dash
Ok guys looking at changing my blob dash to the hawk one but not sure of what I need ? It's only the centre bit that I'm changing but could someone give me a idea of what I need cheers
#2
Scooby Regular
iTrader: (1)
Join Date: Apr 2012
Location: Fife Scotland
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
You ll need the complete centre console mate, all the silver bits, the black sides, the centre arm rest, hawkeye handbrake lever but fitted with the small handbrake cable pull cable from your blob, the small bracket that goes under the top centre vents and the radio brackets as if memory serves me the hawk radio sits at a different angle. When you have all the right bits the job is a breeze
#3
Scooby Regular
Thread Starter
Join Date: Jan 2012
Location: Southam, Warwickshire
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
Cheers buddy so a lot then didn't realise you needed all the handbrake aswell are they different in the hawk then ? As when I was in my mates hawk it didn't look any diff lol
#4
Scooby Regular
iTrader: (1)
Join Date: Apr 2012
Location: Fife Scotland
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
The handbrakes look the same, they might be the same, but its the cable thats different, I think the hawkeye is slightly longer and the handbrake cant be applied properly if not changed for the blob one
#5
Scooby Regular
iTrader: (1)
Join Date: Apr 2012
Location: Fife Scotland
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Here you go mate, looks like all you need, just check for radio brackets and the one under thetop vents http://www.ebay.co.uk/itm/Subaru-imp...item27de8029c6
#7
Scooby Regular
iTrader: (1)
Join Date: Apr 2012
Location: Fife Scotland
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Yep forgot about the above, however I wouldn't go to the expense/trouble of new door cards use and modify the existing hole for the DCCD switches. You ll need to use a piece of plastic to mount the original switch then adapt the hole to fit the switch, all sounds harder than it actually is mate
Thread
Thread Starter
Forum
Replies
Last Post