4 bar map sensor for Ecutek?
08 December 2013, 03:18 PM
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Sep 2013
Location: glasgow
Posts: 880
Likes: 0
Received 0 Likes
on
0 Posts
4 bar map sensor for Ecutek?
Will I need a 4 bar map sensor for an Ecutek remap, hopefully going above 420bhp, or are they only usefull when going mafless?
Car is a widetrack blob, mods will be:
panel filter
3 port bcs
spark plugs
fuel pump
800cc injectors
fpr (possibly)
harvey up pipe and headers
sports cat
exhaust
billet md321t and samco hose
ecutek map
many thanks
Car is a widetrack blob, mods will be:
panel filter
3 port bcs
spark plugs
fuel pump
800cc injectors
fpr (possibly)
harvey up pipe and headers
sports cat
exhaust
billet md321t and samco hose
ecutek map
many thanks
Last edited by just me; 08 December 2013 at 03:24 PM.
08 December 2013, 05:04 PM
#2
It's a case of what boost you are planning to run. A 4 bar will allow up to about 2.9 bar of boost. A 3 bar about 1.9.
Widetrack blob runs 2.6 bar sensor I think, so good for 1.5bar.
All my suggestions allow 0.1 bar margin to make sure overboost is dealt with correctly.
Widetrack blob runs 2.6 bar sensor I think, so good for 1.5bar.
All my suggestions allow 0.1 bar margin to make sure overboost is dealt with correctly.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM