Performance creations mudflaps
#1
Scooby Regular
Thread Starter
Join Date: Apr 2013
Location: Berks
Posts: 4,224
Likes: 0
Received 0 Likes
on
0 Posts
Performance creations mudflaps
Right slightly different question too the norm. I've just fitted the front set to my GB270 no problems, now I have a slight issue with the rears. I appear to be missing the holes for the lower push fitting. I can see where the top one goes but there's nothing to line up with the second one, am I supposed to drill the plastic as well or what?
Any help would be much appreciated.
Any help would be much appreciated.
#2
Scooby Regular
Thread Starter
Join Date: Apr 2013
Location: Berks
Posts: 4,224
Likes: 0
Received 0 Likes
on
0 Posts
Right. If anyone's interested I think I've found the missing hole (ooh matron).
On the GB270 you get an additional piece of trim that's screwed/bonded over the bottom of the rear bumper. The second mounting hole is exactly where it should be, just it's covered by this trim piece. If you get a finger nail underneath it you should be able to feel the edge of the countersinking on the hole, then it's just a case of drilling the over trim.
On the GB270 you get an additional piece of trim that's screwed/bonded over the bottom of the rear bumper. The second mounting hole is exactly where it should be, just it's covered by this trim piece. If you get a finger nail underneath it you should be able to feel the edge of the countersinking on the hole, then it's just a case of drilling the over trim.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM