Power/torque of a vf 43
#4
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jun 2009
Location: teesside
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
It did 392/420 with out meth
This with 20% meth
Mods
Forged 2.5
Ported heads bigger valves
650 injectors
044 pump
Williams Motorsport headers
Harvey Venturi up pipe
3" nur spec
Spec c inlet manifold rotated
This with 20% meth
Mods
Forged 2.5
Ported heads bigger valves
650 injectors
044 pump
Williams Motorsport headers
Harvey Venturi up pipe
3" nur spec
Spec c inlet manifold rotated
#5
Cheers Iain
#7
Scooby Regular
Join Date: Aug 2011
Location: Wiltshire
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
As said I've had mine set up by Iain and then mapped by Bob. Only on v-power as I'm still on stock internals, graph from Bob..
And then this is the graph from S4U when I put it on the rollers....
I've also been on power station's rollers and again that was pretty much the same as S4U. I will say tho that the diff was left in 'auto' when on the rollers and if this made a difference to the power delivery or not I'm not sure...
And then this is the graph from S4U when I put it on the rollers....
I've also been on power station's rollers and again that was pretty much the same as S4U. I will say tho that the diff was left in 'auto' when on the rollers and if this made a difference to the power delivery or not I'm not sure...
Last edited by Pez; 03 March 2013 at 07:36 PM.
Thread
Thread Starter
Forum
Replies
Last Post