richyprodrive1988

Hi. Tried to fit hids to my blob sti today. They won't work. Normal bulbs work fine then as soon as I plug in kit they don't work. All wiring is correct, just 2 wires. And lights work direct from battery. Anyone else had this trouble?

Dan-

You need to wire them up opposite so but red to black and black to red sounds odd but there ground different! i spent hours trying to figure it out!

richyprodrive1988

Thanks for the advice. Will try this tomorrow

richyprodrive1988

So I connect the red to the reflector in rear of lamp and black into the red plug that connected to bulb??

Dan-

looking at my drawing you have a white wire going to the bottom of the H1 bulb you need to connect your black wire from you ballast to this and red wire from the ballast to the black that goes to the bulb housing ground

Dan-

Btw i know i have drawn it the wrong way! Black/White Red/Black cant go wrong

alcazar

iTrader: (2)

Plug and play...LOL

Infected by sti

iTrader: (6)

Just flip the plug around that goes in to the ballast, it looks like it goes one way but it will fit the other, had the same problem as above and as soon as I reversed the plug it fired up first time, had me baffled for ages

kingdom200

yeh i fitted to start with then i flipped the wires and was very confused haha....the only issue i have is if i leave the lights on auto and start the car sometimes they wont turn on until the cars on and i flip the switch on and off