Flashing alarm but no siren ?
#1
Scooby Regular
Thread Starter
Join Date: Jun 2011
Location: Tamworth
Posts: 593
Likes: 0
Received 0 Likes
on
0 Posts
Flashing alarm but no siren ?
Hi guys
I have recently tested my car alarm on my Bugeye and found that I have all the flashing lights but no sound from the siren , is it a separate siren or is it off the car horn ? the horn works fine
Any ideas or suggestions will be greatly appreciated
Cheers
I have recently tested my car alarm on my Bugeye and found that I have all the flashing lights but no sound from the siren , is it a separate siren or is it off the car horn ? the horn works fine
Any ideas or suggestions will be greatly appreciated
Cheers
#2
Scooby Regular
iTrader: (2)
Join Date: Sep 2012
Location: Essex
Posts: 1,250
Likes: 0
Received 0 Likes
on
0 Posts
This will be siren failure, common.
It is a separate siren normally located under the scuttle panel
£57 new from Subaru.
Had the same issue check my thread on this for information.
It is a separate siren normally located under the scuttle panel
£57 new from Subaru.
Had the same issue check my thread on this for information.
Last edited by Inviroman; 02 November 2012 at 02:20 PM.
#5
Scooby Regular
iTrader: (2)
Join Date: Sep 2012
Location: Essex
Posts: 1,250
Likes: 0
Received 0 Likes
on
0 Posts
Look for a gold or silver coloured box about 4 x 6 x 1 inch in size.
The new siren comes with plug and wiring code for the plug
Easy fix and not too expensive, the new siren has been redesigned to prevent the water ingress which is the cause of them failing.
The siren goes in the same place or you can relocate if requires the cable runs back into the car and the four core cable wires to the plug which plugs into the main unit and the single black wire is for the bonnet switch.
You will see when you carry out the replacement.
The new siren comes with plug and wiring code for the plug
Easy fix and not too expensive, the new siren has been redesigned to prevent the water ingress which is the cause of them failing.
The siren goes in the same place or you can relocate if requires the cable runs back into the car and the four core cable wires to the plug which plugs into the main unit and the single black wire is for the bonnet switch.
You will see when you carry out the replacement.
Last edited by Inviroman; 02 November 2012 at 07:09 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
toyney83
General Technical
10
02 October 2015 08:38 PM