scooby if in doubt....

Can any 1 tell me if a small front number plate are illegal ? And if not where I can get 1 done?

tubbytommy

iTrader: (20)

not legal but you can get undersized ones on the net
www.createmyplates.com for example
you need to buy a "show plate"

in the builder part you can specify the size.
but be prepared that if you fit the police will possibly bother you and make you change it and it will be an mot fail as its illegal.

scooby if in doubt....

Aah thanks for that mate, I wasn't sure as I seem to see alot of cars out my way with small front plates

tubbytommy

iTrader: (20)

i have one, it 7 inches by 3 inches.
i have never been bothered by the police in 2 years but mine is an occasional use car and dont drive like an idiot.

just need to change it for the mot

scooby if in doubt....

Yea Iam the same only use me car once a week if that,

craigo

iTrader: (1)

front end looks great !

scooby if in doubt....

Yea Iam liking that mate, gonna order same size I think

Abx

iTrader: (15)

I'd persoanlly go for a 3/4 size, with no border and a large plain font, in 5 or so years of driving with that size I have never been pulled as unless you compare it like for like to a stardard size it does not look too small, again I'm not a mad driver though and no mega loud exhaust so do not give them any excuse to pull.

and on my hatch

F1 CJE UK

iTrader: (8)

small to keep out of the way of the FMIC, never had any issues as the letters are the correct size (just dont take the P*** and you be ok)

Kirstiestar

iTrader: (2)

Nope they are illegal, better to not have one at all than to have a small one, so the old bill told me x

Markfey

iTrader: (7)

If you speak to Scott at coolplates he does some awesome ones that you can create on his website.

It's very subtle but on mine i have the subaru stars in the background and a border that matches the colour of the car. Been stopped numerous times and its never been questioned by the police.

I know its not an answer to your question but it might point you in another direction.

Puff The Magic Wagon!

iTrader: (2)

This is what I did



The font is correct, the size and spacing are correct and the background is reflective. It's also legally placed & the only thing missing is the BS mark but it should pass an MOT & it would have to take a really ar$ey copper to give you a fine for it...

scooby if in doubt....

Think Iam gonna go for the 7x3 as I do like the look of it on tommy's

the hamster

iTrader: (7)

never been pulled with mine on, cost me £8 off ebay

SkydiveMacca

Define legally placed? It's facing the sky, not the front?

bigarf

iTrader: (67)

if the numbers arnt the correct size and correct spacing then they are illegal.
i had a small one on mine,got pulled and the copper gave me a £60 on the spot fine.so i ordered a private plate with less letters so i could have the standered size letters but with the plate cut down so it was smaller.while my documents were at the dvla being swapped over for the new reg i got pulled again on the exact same road.i told the copper i had just been pulled a couple of weeks earlier and had sent my docs off to be swapped on to the new reg so i couldnt have another plate made till i got them back.so like a nice gent that he was,he slapped me with another £60 fine.he then said to me,well you should have just taken the small one off and drove around without one on because thats only a £30 fine.

tubbytommy

iTrader: (20)

i must have a full house wrong size plate,wrong size numbers and incorrectly spaced.

Markyscoob

I have a short number so just hacked the sides off so it matches the width of the Hawk as above. Simples.

ScoobySteve69

iTrader: (13)

Not necessarily I`ve used small plates for 4 years and all have passed MOT

Puff The Magic Wagon!

iTrader: (2)

http://www.legislation.gov.uk/uksi/2.../contents/made

Just needs to be on the front of the car & as vertical as reasonably practical - though I would say I was pushing that boundary a bit...

It's not BS approved either but its also a pre 2001 car.


At the end of the day, its easily recognisable and readable. What they're trying to stop is people changing letters/fonts etc and trying to make them harder to read (ie track/trace).

Doggz

I like the idea of a private plate with the edges trimmed.

ScoobySteve69

iTrader: (13)

This is mine....





And this was one on my FTO (red one)

chrishigham

I always try and get standard size lettering but get the plate as small as possible.

scixer6r

Can we have a close up of that enjine bay please