Water sprays and I/C
#1
Scooby Regular
Thread Starter
I'm posting this message again since no response to 1st time . This is important !
Fourth thrust bearing replaced today at my cost.
Finally discovered why frequent failure of thrust bearing was occuring.
Bloody water from I/C spray found a route from under I/c to clutch operating lever located on top of bell housing .
Rubber gaiter does not fit snugly around lever so water flows into bell housing and directly onto bearing - Result accelerated corrosion of bearing !
You have been warned.
Fourth thrust bearing replaced today at my cost.
Finally discovered why frequent failure of thrust bearing was occuring.
Bloody water from I/C spray found a route from under I/c to clutch operating lever located on top of bell housing .
Rubber gaiter does not fit snugly around lever so water flows into bell housing and directly onto bearing - Result accelerated corrosion of bearing !
You have been warned.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM