hawkeye sti clutch
#2
Scooby Regular
iTrader: (42)
I run an excedy pink in mine and that was spec'd for 450bhp and a 6 speed box
You can't beat them for the price to be honest if you're not planning on giving it too much abuse on the strip, if you're planning on doing lots of launches on the strip though you need to look at an excedy twin plate but they don't come cheap.
You can't beat them for the price to be honest if you're not planning on giving it too much abuse on the strip, if you're planning on doing lots of launches on the strip though you need to look at an excedy twin plate but they don't come cheap.
#3
Former Sponsor
iTrader: (11)
Join Date: Jan 2011
Location: Newcastle Upon Tyne.
Posts: 410
Likes: 0
Received 0 Likes
on
0 Posts
If you are running above 450 BHP you may be better off with a twin plate.
Here is a link to our site.
http://www.ddmperformance.co.uk/detail.php?item_id=96
Or this one will also handle the power you have.
http://www.ddmperformance.co.uk/detail.php?item_id=66
Best regards,
Dave @ DDM Performance
Here is a link to our site.
http://www.ddmperformance.co.uk/detail.php?item_id=96
Or this one will also handle the power you have.
http://www.ddmperformance.co.uk/detail.php?item_id=66
Best regards,
Dave @ DDM Performance
#5
Scooby Regular
iTrader: (67)
Join Date: Oct 2007
Location: w,yorkshire
Posts: 4,061
Likes: 0
Received 0 Likes
on
0 Posts
if you have 450+ in a hawkeye sti then its most probably a 2.5l so will have a lot of torque too.an exedy twin will handle the power fine on track and fast road use,but if its going to get a lot of use on the drag strip then you will burn the top plate out in no time.if its dragging your doing the most of then i would go for a carbonnetics or os giken triple plate.after going through 2 exedy twins through launching i fitted a carbonnetics triple and so far its been ok.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM